TENDER OPPORTUNITY

Gas Strut 700N , Gasket Cover Plate , Washer bonded , Gasket Fuel Level Sensor , Filter Assembly Hydraulic Return , Gauge sight 41mm AF hexagon Torque 9 10 Nm , Cap Sideshift Stabiliser , Pad Wear Upper 6mm Thick , Plug Locking , Mounting Rubber , Mounting Resilient , JCB Logo , Lock Grille , Handle Bonnet , Grommet Blind , Cable Wire 1000mm , Nut Rivet M8 , Beading Rubber , Retainer Hose , Clip E Type , Hose 10 BSP HP 850 Hyd. Pump to Steer VA , Fastener DRIVE , Key 2.2 MM , Decal Power and Eco Mode , Decal , Gaiter Parkbrake Lever , Label Relay , Chart Lubricant , Grip , Decal Care Link , Decal Warning , Label Fuse , Mount Relay , Liner Roof Assembly , Liner Roof , Circlip , Grommet , Screw M6 x 25 , Rubber Pad 30x20x12 , Strut Gas Door , Bush , Screw Grub , Catch Window Lockback , Screw M5x30 Button Head , Door Seal Left Hand , Gasket Door Handle , Lock Cover Door Left Hand Side , Strap Check , Door Seal Right Hand , Lock Cover Door Right Hand , Handle Righthand M6 , Rubber Washer , Handle Assembly Side Window RH , Handle Lefthand , Reflector Reflex White , Tape Reflective White , Window Gasket Right Hand , Screw Button Head , Frame Sealant , Pad Support , Seal Rear Window , Seal Top Rail Window , Loctite 243 As Required , Seal Top Corner Left Hand , Strut Gas Window , Seal Door , Latch Left Hand Assembly , Roller Plastic , Pipe Cover Front , Pipe Cover Side Left Hand , Cover Pipe Front , Cover Pipe Side Right Hand , Clamping Ring , Cover Inner Fender Leftside , Joint Ball , Pin Spring 8mm Clevis , Knob Assembly With Switch , Bearing , Gaiter Excavator Lever , Switch Dump , Clip Safety , Lever Parking Brake Red Grip , Knob With Switch , Label Gearlever 4SP , Gaiter Gear Lever Non Soundproofed , Gaiter , Throttle Hand Knob , Gaiter Single , Plate Retaining Gaiter , Coupling , Mount Resilient , Pin Tension , Decal Dipper 3DX Super Army , Decal JCB 540 x 169 , JCB Decal Artwork Army , Decal 4 X 4 Small , Decal 4 X 4 Big , Extinguisher Fire , Band , Bearing Taper Roller , Seal , Bearing Needle Roller NK 45by30 , O Ring , Bearing Roller , Bolt 1 unf X 8 long TORQUE 607N M , Nut 1 UNF , Washer Hardened FIT UNDER IT.2 , Plug Breather , Seal Brake Piston Square Section , Cap Fuel Tank , Brg Tapper Roller , THRUST BEARING , Plug Filler 33mm Head see TI Gen245 Total Quantity : 259

Status:OpenTender No:GEM/2026/B/8252695
← Back to results
Tender ValueNot Disclosed
Published On09 Nov 2026
Submission Deadline19 Nov 2026

Overview

Category
Domestic Tenders
Country
India
State
Rajasthan

Important Dates

Publication Date
09 Nov 2026
Submission Deadline
19 Nov 2026