Still Ball Mill? Now Turn to New Product

SCM series super thin mill from Shibang carries its proven production experience for more than 15 years. The company absorbs technical innovations from abroad and hone the same at home. Reviews, research and try on 12 kinds of mills and horizontal hammer crushers. And finally developes its high-efficiency and low-cost super thin mill by investigation and trial.

SCM super-micro mill is an equipment which produces thin powder and super thin powder. It is applicable to non-flammable and non-explosive materials with hardness less than 6, such as calcite, chalk, limestone, dolomite, kaolin, bentonite, talcum, talc, magnesite, illite, pyrophyllite, vermiculite, sepiolite, attapulgite, rectorite, diatomite, barite, gypsum, alum earth, graphite, fluorite, variscite, potash ore, floatstone.

The technical features and benefits of the super thin mill are: High efficiency, the output is 40% higher than airflow mill and whisk mill in same condition of finished particle size and power of motor.

It has high using rate of the quickwear part. It ensures high safety and greater environmental protection controlling pollution and noise by using dust cleaner and muffler, which achieves environmental protection requirement.

System

The whole system of SCM consists of main unit, deceleration machine, classifier, blower, hammer crusher, dustpan elevator, electro-magnetic vibrating feeder, impulse dust cleaner, piping device, cyclone collector device, classifier, high-pressure motor and muffler.

The main motor drives main axle and every layer rotating by reducer. Dail drives numbers of rollers rolling and rotating in the ring by pintles.

Big sized materials are crushed into smaller particles by hammer crusher, which are transported to store house by elevator. The electro-magnetic vibrating feeder send the materials evenly to the middle of the upper dial. Under the function of the eccentricity, the materials scatter to the side of the circle and fall into the ring to be pressed, crushed and milled into pieces by rollers. After the first crush, materials fall into the second and the third layer. The pumping of the high-pressure centrifugal blower put the outside air into the machine. The coarse powder will be brought into the classifier.The rotating turbine in the collector makes the coarse particles fall back for regrinding. The fine particles will come into the cyclone collector with the airflow and discharged by the discharging valve on the bottom of the collector. They are the final products. The airflow with little dust will be discharged through blower and muffler after being purified by the cyclone collector.